Cellar Pro Split System

The CP 3000S wine cellar cooling unit has a cooling capacity of up to 600 cubic feet.

Wall mounted - available in either Vertical or Horizontal evaporator 

Ceiling mount Cellar Pro 3000 - 3000Scm – can be mounted adjacent to the ceiling, when there isn't enough room in the ceiling joists.  

For cellars up to 600 cubic feet.  

Recessed Ceiling mount for up to 600 cubic feet. 

The CP 4000S wine cellar cooling unit has a cooling capacity of up to 1000 cubic feet.  

Wall mounted - available in either Vertical or Horizontal evaporator 

The CP 4000S WATER cooled wine cellar cooling unit has a cooling capacity of up to 1000 cubic feet.  

Recessed Ceiling Mount 4000 for cellars up to 1000 cubic feet  

The CP 6000S wine cellar cooling unit has a cooling capacity of up to 1500 cubic feet.

Wall mounted - Water cooled also available 

Recessed Ceiling Mount 6000 for cellars up to 1500 cubic feet

The CP 8000S wine cellar cooling unit has a cooling capacity of up to 2000 cubic feet.

Wall mounted - Water cooled also available 

Recessed Ceiling mount Cellar Pro 8000Scmr – for cellars up to 2000 cubic feet

With the bottle probe the cooling unit cycles on and off with regards to the temperature in the bottle as opposed to the temperature in the wine cellar.

Remote display / Control unit

Allows control panel to be in a different location than the cooling unit. 

With this kit, the cooling unit's cold air intake & exhaust can be ducted up to 100 equivalent feet.
The Cellar Pro wine cooling units can now be completely ducted when the front duct kit is combined with one of the rear duct kits! Bottle Probe and Remote Display included with this option.

Also known as Compressor Heater.

Cellar Pro's Crankcase Heater is required if the condenser (rear) of the cooling unit is exposed to temperatures below 40°F - but not lower than 20°

...already included with purchase of the outdoor hood.  

Fan Cycling Switch allows for cooling units including the VS Series, 1800 Series, Splits and Air Handler Series, to operate in temperatures as low as  -20°F.

The outdoor hood is required when the Cellar Pro condenser unit will be installed outdoors. One size fits all CellarPro Split condensing units.

Compressor Heater included with Outdoor Hood
 

Need your cellar a bit colder for immediate serving temperature of white wine then the White Wine modification will allow the cellar to be programmed for as low as 45F

Please note, this temperature is much colder than what would normally be used for aging wine cellars.  

Cellar Pro's Louvered Wood Grill Cover is designed to fit over all CP 3000S,4000S & Mid Size VS Through the wall - wine cellar refrigeration systems.

Dimensions:
20 19/32"W x 1 7/16"D x 26 3/32"H

Must be specified at time of ordering cooling unit.

Cellar Pro is now available in 220V / 50Hz Option, for European Electrical needs.