D025 (previously known as 24S025 or 1/4 Ton)
- Estimated Room Size: up to 800 cubic feet
- Digital Thermostat
- Self contained, pre-charged
- Current: 8.6 amps
- Circuit: 15 amps
- 14"w x 14"h x 33"l
- Approx. 80 lbs
- 8" Round Insulated Ducting, (not included)
NOTE: The WG 1/4 ton is not exactly as shown in picture - requires duct collars to be attached to the respective openings
Although the cooling units are rated for various size rooms, the thermal load may require a larger sized cooling unit. Thermal load may be affected by glass in the cellar, room positioning or other factors. Please let a Rosehill Wine Cellar rep make some suggestions for you if needed.
See Additional Information tab if present for more details
All our Wine Guardian products are shipping directly from Wine Guardian so you are guaranteed the most up to date technology available.
How The Wine Guardian Ducted System works - The Simple Version
The Wine Guardian ducted cooling unit is installed in an adjacent room and pumps cold air into cellar via one or more cold air supply ducts. A warm air return is also positioned in the cellar to allow for air circulation to go back to the Wine Guardian.
Installation site should be within 25ft of the Wine Cellar. Utility rooms, mechanical rooms, attic or crawl spaces are potential locations. The Wine Guardian can be mounted on the ceiling, the wall or the floor. Wine Guardian airflow and performance ratings are based on the use of 25 feet of ductwork per side.
Integrated temperature and humidity gauge included with all ducted units. A digital thermostat & 25ft of thermostat wire also comes with the unit.
How it works - A Bit More Technical
Wine Guardian contains both an Evaporator and Condenser. There is a constant exchange of air with the Wine Guardian & the cellar. Cold air supply is ducted into the wine cellar through one of more ducts depending on size and configuration of the room. Air from the wine cellar returns to the Wine Guardian via a return air duct where it is cooled and supplied back into the cellar.
Multi panel construction (for attaching ducts) allows for flexible installation; of floor, ceiling or wall mounting of the unit. Designed for keeping properly insulated wine cellars at 55/56 degrees. Not meant for lower temperature applications, but potentially can be configured for as low as 50 degrees. Can also be configured for 72/74 degrees with humidity specific requirements such as artwork, archives, musical instruments.
For the standard Wine Guardian, the installation site temperature should not be higher than 95 degrees; if higher, then you may need to look at Water Cooled Option or have fresh air duct to the installation site AND vent the exhaust.
STANDARD UNIT - To also decrease the temperature of the installation site, warm air exhaust from the Wine Guardian condenser can be ducted out of the room. If the install room is at least 2 1/2 times larger than the wine cellar, then generally no need to duct the hot air exhaust as room temperature shouldn't change.
WATER COOLED UNIT - Because this unit doesn't get hot - it can be installed in a closet or confined space. The water cooled can now be ducted into home swimming pools, please specify at time of order your interest in doing this.
When should I spec a water-cooled WG?
Water- cooled units are ideal for most high-rise apartment complex applications where most have chiller or cooling towers as part of the building mechanical system. Another application would be restaurants or country clubs that have the ability to tie the system into the dishwashing system. The water-cooled Wine Guardian is physically the same size as the standard air-cooled model but requires no airflow across its condenser. The unit uses water instead of air to cool its condenser, therefore no outside venting or cool air to the unit is required for operation. The system only uses water when there is a call for cooling. When the temperature in the wine cellar is satisfied the compressor and water shut off. The water-cooled Wine Guardian requires two water connections, one (1) in, one (1) out, primary power, drain and wine room side ductwork connections.
Each of the ducted systems already comes with two duct collars (one for supply and one for return on the evaporator) These two duct collars will satisfy most configurations. You only need to order additional duct collars if you plan on having secondary supply or will be ducting the condenser side.
The Ducted system also already comes with the Remote Interface Controller.
VERTICAL Systems also available for the 1/2 ton and 1 ton - The vertical design offers more flexibility for installation in more confined spaces. The vertical ducted or water cooled ducted system takes up less space then the traditional horizontal units. See Additional Info tab for sizes.
Wine Guardian - With Humidifier Attached
Wine Guardian - Example of Airflow
Multi Panel Construction creates options for you to position ducts
Wine Guardian - Overview
Wine Guardian - Vapor Compression System
What if I have more than 5500 Cubic feet?
Larger applications are easily covered using multiple units.
What are other Wine Guardian features?
- 24/7 Factory Service Hotline!!!
- One Return and One Supply Duct Collar are included for the evaporator side.
- The unit may be ceiling, wall, or floor mounted within the wine cellar, or may be located in an adjoining space.
- The unit is designed for easy installation--refrigeration contractor is not needed. All panels are removable for maintenance and duct connections.
- Integrated Digital Controller: adjust temperature and view humidity from the same digital display. If humidifier or heater option is purchased then you will be able to control humidity & heat with this controller as well.
- Refrigerant is R-134a.
- Wine Guardian is essentially maintenance free. The refrigeration system is hermetically sealed and requires no maintenance. Fan motors have permanent lubrication. Filters should be checked monthly and evaporator coils checked every three months. All panels can be easily removed.
- Wine Guardian conforms to UL & CSA standards.
- Made in the USA
All-In-One Interface Controller:
View all options available with the Wine Guardian via a singular control panel. View digital readout of temperature and humidity in single location. Temperature is controlled on this panel, cellar's humidity will be displayed. You will need the WG humidifier option to adjust humidity on this panel. If you have the WG heater and humidifier options, then these will be connected to this singular control panel. Also included - Temperature & humidity alarm systems. Controller can be installed remotely and used with the optional remote sensor. Connect up to three optional remote sensors within a larger or unusually shaped wine cellar to measure temperature and humidity in various areas; panel controls their average value.
WHAT'S BETTER? In-bottle temperature probe OR a wall-mounted thermostat
According to Wine Guardian - Wall-mounted thermostats are much better at keeping the wine temperature constant.
The accuracy of in-bottle probes or sensors is similar to that of wall-mounted thermostats, usually plus or minus 1°F. Which means that the sensor will turn on the cooling unit when the temperature is 1°F above the set-point temperature and will keep it running until the temperature falls 1°F below set-point. This is a 2°F swing in the temperature. For in-bottle probes, this is the actual temperature swing of the wine in the bottle and it occurs each time the cooling unit cycles on and off, maybe several times per hour in warmer weather. For a wall-mounted thermostat, the cellar air temperature will go through the same 2°F swing, but the wine temperature inside the bottle will not because of the thermal mass of the liquid and the glass. Actual temperature measurements of the liquid will not vary more than a small fraction of a degree Fahrenheit. Air temperature will change whenever the cellar door is opened.
Up to 3 remote sensors can be installed and positioned within different areas of your wine cellar, be sure to order extra remote sensors at the time of ordering your Wine Guardian ducted cooling unit.
Wine Guardian Air Innovation Ducted wine cellar cooling units, are American made. Produced and shipped from North Syracuse, NY, New York, United States of America, 13212 or from the New Jersey office Franklin Lane, NJ, 07417 USA. Wine Guardian Wine Cellar Cooling Units are available for shipping within the USA, Canada and internationally
If you would like racking as well, we will be happy to customize a design and obtain a shipping quote for your entire order. Click HERE to go to Racking Pages.
When adding the options below. Please choose all the options you would like and then add the entire bundle to the cart once.
Shipped directly from the manufacturer so you get the most up to date technology available.
IMPORTANT SHIPPING INFORMATION
US shipping cost is fixed for all of continental US. Extra charges may apply for Hawaii and Alaska.
Canadian shipping cost indicated is to major Canadian city. Extra charges may apply within Canada for smaller towns or remote locations.
UPON RECEIPT OF GOODS:
Please inspect for any damage and verify the number of boxes as compared to the waybill. Please indicate any damage, wear & tear to boxes or discrepancies while you are signing for the shipment.
Please count your boxes and inspect for damage prior to signing receipt of boxes.
IF YOU HAVE DAMAGED ITEMS:
Please report damage to us as soon as possible. Generally it is better to accept the box(es) indicating damage on the waybill as opposed to refusing the shipment.
We will ship you new replacement items immediately, at no charge, as long as you indicated on the waybill that there was damage. We insure all items we ship, however, in order to make a claim it must be started within 4 business days of shipping.
If you discover damage after the delivery person has left or you did not sign for the items received please contact us as well as contacting the shipping company right away.
Please be assured that we stand behind our products and our shipping methods. You buy with confidence when you buy from Rosehill Wine Cellars.
Do not throw away boxes/any packaging material!! Damaged product must remain in the original packaging in order to process damage claim. Please contact Rosehill ASAP at 1-888-253-6807.
Wine Guardian Ducted System Installation, Operation and Maintenance Manual
Quick Start Guide
Wine Guardian Ducted System Spec Sheet
Wine Guardian Water-cooled Ducted System Spec Sheet
Wine Guardian Ducted System Options Spec Sheet
Sizes of Standard Ducted Horizontal & Vertical Wine Guardian
Wine Guardian Ducted System Dimensional Data
Wine Guardian Warranty Information
Use our Wine Guardian cooling unit calculator to determine the right Wine Guardian for your application.